Freeze Frame Data
WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Data stored at the time of trouble occurrence is shown on the display.
- Each time a trouble occurs, the latest information is stored in the freeze frame data in memory.
- If a freeze frame data is not properly stored in memory (due to a drop in VDCCM power supply, etc.), a DTC suffixed with a question mark "?" appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
DISPLAY CHART
| Display | Contents to be monitored |
|---|---|
| Steering angle sensor | Steering angle detected by steering angle sensor is displayed. |
| Yaw rate sensor | Vehicle angular speed detected by yaw rate sensor is displayed. |
| Lateral G Sensor | Vehicle lateral acceleration detected by lateral G sensor is displayed. |
| Pressure Sensor | Brake fluid pressure detected by pressure sensor is displayed. |
| Vehicle Speed | Vehicle speed calculated by VDC control module is displayed. |
| FR Wheel Speed | Wheel speed detected by front ABS wheel speed sensor RH is displayed in km/h or MPH. |
| FL Wheel Speed | Wheel speed detected by front ABS wheel speed sensor LH is displayed in km/h or MPH. |
| RR Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor RH is displayed in km/h or MPH. |
| RL Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor LH is displayed in km/h or MPH. |
| Acceleration opening angle signal | Acceleration opening is displayed. |
| Engine Speed | Engine speed on malfunction occurrence is displayed. |
| Gear position | Gear position on malfunction occurrence is displayed. |
| IG power supply voltage | Voltage supplied to VDC control module is displayed. |
| Absolute angle recognition flag | Whether the absolute angle of the steering angle sensor was determined is displayed. |
| EAM signal | Engine control command signal is displayed. |
| VDC Control Flag | VDC control condition is displayed. |
| EBD Control Flag | EBD control condition is displayed. |
| TCS Control Flag | TCS control condition is displayed. |
| ABS Control Flag | ABS control condition is displayed. |
| VDC OFF light | ON/OFF condition of the VDC operated by the driver is displayed. |
| Brake Switch | Brake ON/OFF is displayed. |
| Fr Rr G sensor Output | Vehicle longitudinal acceleration detected by the longitudinal G sensor is displayed. (MT vehicles only. AT vehicles are fixed at -0.1 m/s2 .) |
| Clutch Switch | Clutch ON/OFF is displayed. (MT vehicles only. AT vehicles fixed at OFF.) |
| Reverse Signal | Reverse gear ON/OFF is displayed. (MT vehicles only. AT vehicles fixed at OFF.) |