Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Instrumentation System & Driver Information System - Instrumentation/Driver Info) >> Combination Meter >> Removal

Combination Meter: Removal

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Set the tilt steering at the lowest position. Pull out steering wheels with telescopic functions all the way.
  3. Remove the plastic hook (A), and detach the meter visor.
    Fig 1: Identifying Plastic Hooks
    G05663809Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the screws of the combination meter, and pull on the meter while tipping it towards yourself.
    Fig 2: Locating Screws Of Combination Meter
    G05663635Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the connector in the rear side of combination meter to remove meter.
CAUTION:
  • Be careful not to damage the meter or instrument panel.
  • Pay particular attention to avoid damaging the meter glass.
scientia non olet · About Mike's Workshop Manuals