Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Anti-Lock Brake System (Abs)) >> Rear ABS Wheel Speed Sensor >> Installation

Rear ABS Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

CAUTION: Be careful not to damage the sensor.

Tightening torque: 

Sensor: 

7.5 N.m (0.76 kgf-m, 5.5 ft-lb) 

Bracket: 

33 N.m (3.3 kgf-m, 24 ft-lb) 

NOTE: Check the identification (mark) on the harness to make sure there is no warpage. (RH: K5 (White), LH: K6 (Yellow))