Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Controls - Engine (Diagnostics) (H6DO)) >> Diagnostics for Engine Starting Failure >> Procedure

Diagnostics for Engine Starting Failure: Procedure

WARNING: This page is about a different variant/trim than selected.
DIAGNOSTICS PROCEDURE CHART

1. Check of the fuel amount
↓
2. Inspection of starter motor circuit. <Refer to STARTER MOTOR CIRCUIT , Diagnostics for engine Starting Failure. >
↓
3. Inspection of ECM power supply and ground line. <Refer to CHECK POWER SUPPLY AND GROUND LINE OF ENGINE CONTROL MODULE (ECM) , Diagnostics for engine Starting Failure. >
↓
4. Inspection of ignition control system. <Refer to IGNITION CONTROL SYSTEM , Diagnostics for engine Starting Failure. >
↓
5. Inspection of fuel pump circuit <Refer to FUEL PUMP CIRCUIT , Diagnostics for engine Starting Failure. >
↓
6. Inspection of fuel injector circuit <Refer to FUEL INJECTOR CIRCUIT , Diagnostics for engine Starting Failure. >
scientia non olet · About Mike's Workshop Manuals