Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2008 >> Forester XT, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls - Engine (Diagnostics) (H4SO)) >> System Operation Check Mode >> Operation >> Idle Speed Control

Idle Speed Control

WARNING: This page is about a different variant/trim than selected.
CAUTION: After executing the operation check mode, perform the Clear Memory Mode < Ref. to OPERATION , Clear Memory Mode>.
  1. On the « System operation check mode » display screen, select the {Idle Speed Control}.
  2. On the « Start the Engine » display screen, start the engine and click the [OK] button.
  3. In the « Idle Engine Speed Control » screen, click the ↑ button or the ↓ button to change the setting values, then click the [OK] button.

    Setting is possible in a range between 500 rpm - 2,000 rpm, in increments of 50 rpm. However, the engine speed that can actually be controlled will vary depending on the vehicle.

  4. Click the [Cancel] button to end the idle speed control. The screen will return to the « System Operation Check Mode » screen.
    NOTE: For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".
scientia non olet · About Mike's Workshop Manuals