Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2007 >> Outback XT Limited, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls (Diagnostics) (H4SO)) >> Drive Cycle >> Procedure >> Preparation For Drive Cycle

Preparation For Drive Cycle

WARNING: This page is about a different variant/trim than selected.
  1. Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 l  (5.3 - 10.6 US gal, 4.4 - 8.8 lmp gal)].
  2. After performing the diagnostics and clearing the memory, check for any remaining unresolved trouble data. <Ref. to CLEAR MEMORY MODE . >
  3. Disconnect the test mode connector.
    NOTE:
    • Perform the diagnosis after warming up the engine except when the engine coolant temperature at starting is specified.
    • Perform the diagnosis twice if the DTC marked with *. After completing the first diagnosis, stop the engine and perform second diagnosis in same condition.
scientia non olet · About Mike's Workshop Manuals