Mode $01 (Current Powertrain Diagnostic Data)
WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
Refers to data denoting the current operating condition of analog input/output, digital input/output and/or the powertrain system.
A list of the support data and PID (Parameter Identification) codes are shown in the following table.
CURRENT POWERTRAIN DIAGNOSTIC DATA
| PID | Data | Unit of measure |
|---|---|---|
| 01 | Number of emission-related powertrain trouble codes and MIL status | ON/OFF and number |
| 03 | Fuel system control status | - |
| 04 | Calculated engine load value | % |
| 05 | Engine coolant temperature | °C |
| 06 | Short term fuel trim | % |
| 07 | Long term fuel trim | % |
| 0B | Intake manifold absolute pressure | kPa |
| 0C | Engine revolution | rpm |
| 0D | Vehicle speed | km/h |
| 0E | Ignition timing advance | ° |
| 0F | Intake air temperature | °C |
| 10 | Air flow rate from pressure sesnor | g/sec |
| 11 | Throttle valve opening angle | % |
| 13 | Check whether oxygen sensor is installed. | - |
| 14 | Oxygen sensor output voltage and short term fuel trim associated with oxygen sensor-bank 1 | V and % |
| 15 | Oxygen sensor output voltage and short term fuel trim associated with oxygen sensor-bank 2 | V and % |
| 1C | On-board diagnosis system | - |
| 24 | A/F value and A/F sensor output voltage | - and V |
NOTE:
Refer to general scan tool manufacturer's instruction manual to access generic OBD-II PIDs (MODE $01).