Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2006 >> Forester XT Limited, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4DOTC) >> Clear Memory Mode >> Operation >> SUBARU Select Monitor (OBD Mode)

SUBARU Select Monitor (OBD Mode)

  1. On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
  2. On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES] key.
  3. Press the [YES] key after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» display screen, select {OBD System} and press the [YES] key.
  5. On the «OBD Menu» display screen, select {DTC Clear} and press the [YES] key.
  6. When the "Perform Diagnostic Code(s) Clear" is shown on the screen, press the [YES] key.
  7. Turn the ignition switch to OFF and then turn the Subaru Select Monitor switch to OFF.
    NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
scientia non olet · About Mike's Workshop Manuals