Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2006 >> Forester X, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission) >> Reduction Driven Gear >> Installation >> MPT Model

MPT Model

WARNING: This page is about a different variant/trim than selected.
  1. Set the select lever to "P" range.
  2. Using a plastic hammer, install the reduction driven gear assembly and the new washer, and tighten the new lock nut.

    Tightening torque: 

    100 N.m (10.2 kgf-m, 73.8 ft-lb) 

    Fig 1: Tightening Lock Nut Using ST
    G04994191Courtesy of SUBARU OF AMERICA, INC.
  3. After tightening, stake the lock nut securely.
  4. Join the transmission case and the extension case, and then install the rear vehicle speed sensor. <Ref. to INSTALLATION  EXTENSION CASE. >
  5. Install the transmission assembly to the vehicle. <Ref. to INSTALLATION  AUTOMATIC TRANSMISSION ASSEMBLY. >
scientia non olet · About Mike's Workshop Manuals