Read DTC

Prepare the Subaru Select Monitor kit.

Fig 1: Identifying Subaru Select Monitor Kit
Courtesy of SUBARU OF AMERICA, INC.
Connect the diagnosis cable to Subaru Select Monitor.
Insert the cartridge to Subaru Select Monitor. <Ref. to SPECIAL TOOL PREPARATION TOOL, GENERAL DESCRIPTION. >

Fig 2: Inserting Cartridge To Subaru Select Monitor
Courtesy of SUBARU OF AMERICA, INC.
Connect the Subaru Select Monitor to the data link connector.
1. Data link connector is located in the lower portion of the instrument panel (on the driver's side).
  
  Fig 3: Identifying Data Link Connector
  Courtesy of SUBARU OF AMERICA, INC.
2. Connect the diagnosis cable to data link connector.
Turn the ignition switch ON (engine is OFF), and the Subaru Select Monitor switch ON.

Fig 4: Identifying Power Switch
Courtesy of SUBARU OF AMERICA, INC.
On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
On the «System Selection Menu» display screen, select the {Brake Control} and press the [YES] key.
Press the [YES] key after the VDC type is displayed.

On the «Brake Control Diagnosis» screen, select the {Diagnostic Code(s) Display}, and then press the [YES] key.

NOTE:

For details concerning operation procedure, refer to the " SUBARU SELECT MONITOR OPERATION MANUAL ".
For details concerning DTC, refer to "LIST OF DIAGNOSTIC TROUBLE CODE(DTC) ".
<Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >
A maximum of three DTCs are displayed in the order of occurrence.

Fig 5: Identifying Diagnostic Trouble Codes

Courtesy of SUBARU OF AMERICA, INC.

DATA DISPLAY CHART

Display	Contents of Display
Previous	The latest DTC of the failures in the past is displayed on the Subaru Select Monitor display.
Second previous	The second latest DTC of the failures in the past is displayed on the Subaru Select Monitor display.
Third previous	The third latest DTC of the failures in the past is displayed on the Subaru Select Monitor display.
* If the failure is occurring, "Current" is displayed on the screen.