Read Current Data
- On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
- On the «System Selection Menu» display screen, select the {Brake Control} and press the [YES] key.
- Press the [YES] key after the VDC type is displayed.
- On the «Brake Control Diagnosis» display screen, select the {Current Data Display/Save}, and then press the [YES] key.
- On the «Data Display Menu» screen, select the {Data Display} and press the [YES] key.
- Using the scroll key, scroll the display screen up or down until the desired data is shown on the screen.
- A list of the support data is shown in the following table.
DATA DISPLAY CHART
| Display | Contents to be monitored | Unit of measure |
|---|---|---|
| FR Wheel Speed | Wheel speed detected by front ABS wheel speed sensor RH is displayed. | km/h |
| FL Wheel Speed | Wheel speed detected by front ABS wheel speed sensor LH is displayed. | km/h |
| RR Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor RH is displayed. | km/h |
| RL Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor LH is displayed. | km/h |
| Steering angle sensor | Steering wheel angle detected by steering angle sensor is displayed. | deg |
| Yaw Rate Sensor | Vehicle angular speed detected by the yaw rate sensor is displayed. | deg (deg/s) |
| Pressure sensor (P) | Brake fluid pressure detected by the primary pressure sensor is displayed. | bar |
| Pressure sensor (S) | Brake fluid pressure detected by the secondary pressure sensor is displayed. | bar |
| Lateral G Sensor | Vehicle lateral direction acceleration detected by lateral G sensor is displayed. | m/s (m/s2 ) |
| IG Power Supply Voltage | Voltage supplied to the VDCCM is displayed. | V |
| Valve Relay | The valve relay operating condition is displayed. | ON or OFF |
| Motor Relay | The motor relay operating condition is displayed. | ON or OFF |
| Motor Relay Monitor | The motor relay operating condition is displayed. | ON or OFF |
| VDC ON | VDC operation condition is displayed. | ON or OFF |
| VDC Warning Light | ON/OFF condition of the VDC warning light/VDC OFF indicator light is displayed. (ON is displayed when there is a VDC failure.) | ON or OFF |
| ABS Warning Light | ON/OFF condition of the ABS warning light is displayed. | ON or OFF |
| VDC OFF Light | ON/OFF condition of the VDC warning light/VDC OFF indicator light is displayed. (ON/OFF is displayed by operating the VDC OFF switch and EAM signal.) | ON or OFF |
| EBD Warning Light | ON/OFF condition of the EBD warning light is displayed. | ON or OFF |
| EAM Signal | Engine control command signal is displayed. | 1 or 0 |
| PATA Signal | ON/OFF condition of the VDC OFF switch is displayed. | ON or OFF |
| Gear Position | Gear position is displayed by number. 0: N or P, 1: 1st, 2: 2nd, 3: 3rd, 4: 4th, 7: R | - |
| Engine Speed | Engine speed is displayed. | rpm |
| PW Signal | Acceleration opening is displayed. | % |
| Car Line | Vehicle type is displayed by number. Normally "1." | - |
NOTE:
For details concerning operation procedure, refer to the " SUBARU SELECT MONITOR OPERATION MANUAL
".