Confirmation Of Current Setting

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

On the << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
On the << System Selection Menu >> display screen, select the {Integ. Unit mode} and press the [YES] key.
On the << Integ. Unit mode failure diag >> display screen, select the {Current Data Display & Save} and press the [YES] key.
On the << Current Data Display & Save >> display screen, select the {12 Data Display} and press the [YES] key.
Using the scroll key, scroll the display screen up or down until the desired data is shown.
Display the following items and record the settings.
Required items for new registration (Except for system not equipped)

ITEM REFERENCE CHART

Item	Item to confirm				Remarks
Key No. to register	1	2	3	4	Registered ID type
Off delay	OFF	Long	Normal	Short	Setting for lighting off time
Auto-lock	60, 50, 40, 30, 20		OFF		(Unit sec.)
Rr defogger op. mode	Normal		Continuous
Wiper deicer op. mode	Normal		Continuous		Optional setting
Security Alarm Setup	ON		OFF
Impact Sensor Setup	ON		OFF		Optional setting
Alarm monitor delay setting	ON		OFF
Lockout prevention	ON		OFF
Impact Sensor	Yes		No		Optional setting
Siren setting	Yes		No		Optional setting
Answer-back buzzer setup	ON		OFF		Not equipped
Hazard answer-back setup	ON		OFF
Automatic locking setup	ON		OFF
Ans.-back Buzzer	Yes		No		Not equipped
Auto locking	Yes		No
Door open warning (prevention of battery run-out)	Yes		No
A/C ECM setting	Yes		No		Model with auto A/C
P/W ECM setting	Yes		No		Not equipped
Center display failure	Yes		No		Model with center display
Wiper deicer	Yes		No		Optional setting
Rear fog light setting	Yes		No		Optional setting
Factory initial setting	Manufacture		Market		Not change to Manufacture mode