With SUBARU Select Monitor

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data.
Remove foreign matter (dust, water and oil etc.) from the body integrated unit connector during removal and installation.
For the model with immobilizer, registration of immobilizer may be needed after the replacement of controller and etc. For detail procedure, refer to "REGISTRATION MANUAL FOR IMMOBILIZER".

NOTE:

To check harness for broken wires or short circuits, shake the problem part or connector.
Check List for Interview < Ref. to Check List for Interview >

HARNESS REFERENCE CHART

Step		Check	Yes	No
1 CHECK PRE-INSPECTION. Ask the customer when and how the trouble occurred using interview check list. < Ref. to Check List for Interview > Check the display of communication error display. (Combination meter, odo/trip meter)		Is communication error displayed?	Go to step 3 .	Go to step 2.
2 BASIC INSPECTION. Check the components which might affect body control. < Ref. to , INSPECTION , General Description.>		Is the component that might influence the body control problem normal?	Go to step 3.	Repair or replace each unit.
3 CHECK INDICATION OF DTC. Read the DTC. < Ref. to , READ DIAGNOSTIC TROUBLE CODE (DTC) , OPERATION, Subaru Select Monitor.> NOTE: If the communication function of the Subaru Select Monitor cannot be executed normally, check the communication circuit. < Ref. to , COMMUNICATION FOR INITIALIZING IMPOSSIBLE , Diagnostic Procedure with Diagnostic Trouble Code (DTC).> Record all DTCs.		Is DTC displayed?	Go to step 5.	Go to step 4.
4 PERFORM THE GENERAL DIAGNOSTICS. Inspect using "General Diagnostics Table". < Ref. to General Diagnostic Table .>		Is the result of inspection OK?	LAN system is normal.	Go to step 5.
5 PERFORM THE DIAGNOSIS. Fix the wrong part. Perform the clear memory mode. < Ref. to , CLEAR MEMORY MODE , OPERATION, Subaru Select Monitor.> Read DTC. < Ref. to , READ DIAGNOSTIC TROUBLE CODE (DTC) , OPERATION, Subaru Select Monitor.>		Is DTC displayed?	Repeat step 5 until DTC is not shown.	Finish the diagnosis.