Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2005 >> Baja Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Anti-Lock Brake Control System - Vehicle Dynamics Control (VDC)) >> VDC Sequence Control >> Operation >> VDC Sequence Control With SUBARU Select Monitor

VDC Sequence Control With SUBARU Select Monitor

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In the event of any trouble, the sequence control may not be operative.
  1. Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
  2. Turn the ignition switch to ON.
  3. Set the Subaru Select Monitor switch to ON.
  4. Set the Subaru Select Monitor to the "Brake Control" mode.
  5. When the "VDC Inspection Mode" is selected from the "Function check sequence" menu, the "VDC sequence control" will start.
  6. Since "Press the [YES] key" is displayed, press the YES key.
  7. Operation points will be displayed on the Subaru Select Monitor.
scientia non olet · About Mike's Workshop Manuals