Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2004 >> Outback Base, 4D Sedan >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Manual Transmission And Differential) >> Main Shaft Assembly >> Installation

Main Shaft Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the needle bearing and oil seal onto the front of transmission main shaft assembly.
    NOTE:
    • Wrap the clutch splined section with vinyl tape to prevent damage to oil seal.
    • Apply grease (Unilube #2 or equivalent) to the sealing lip of oil seal.
    • Use a new one.
  2. Install the needle bearing outer race knock pin hole into transmission case knock pin.
    NOTE: Align the end face of seal with surface (A) when installing oil seal.
    Fig 1: Installing Needle Bearing Outer Race Knock Pin Hole Into Transmission Case Knock Pin
    G00916468Courtesy of SUBARU OF AMERICA, INC.
  3. Install the drive pinion assembly. Refer to INSTALLATION  , Drive Pinion Shaft Assembly.
  4. Install the transmission case. Refer to INSTALLATION  , Transmission Case.
  5. Install the transfer case with extension case assembly. Refer to INSTALLATION  , Transfer Case and Extension Case Assembly.
  6. Install the manual transmission assembly to vehicle. Refer to INSTALLATION  , Manual Transmission Assembly.
scientia non olet · About Mike's Workshop Manuals