Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2004 >> Impreza RS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine (Diagnostics) (H4SO) >> Clear Memory Mode >> Operation >> SUBARU Select Monitor (OBD Mode)

SUBARU Select Monitor (OBD Mode)

  1. On << Main Menu >> display screen, select the {2.Each System Check} and press the [YES] key.
  2. On << System Selection Menu >> display screen, select the {Engine Control System} and press the [YES] key.
  3. Press the [YES] key after the information of engine type is displayed.
  4. On <<Engine Diagnosis >> display screen, select the {OBD System} and press the [YES] key.
  5. On << OBD Menu >> display screen, select the {4. Diagnosis Code(s) Cleared} and press the [YES] key.
  6. When the "Clear Diagnostic Code?" is shown on the display screen, press the [YES] key.
  7. Turn the Subaru Select Monitor and ignition switch to OFF.
NOTE:
  • After the memory has been cleared, the idle air control solenoid valve must be initialized. To do this, turn the ignition switch to ON position. Wait 3 seconds before starting the engine.
  • For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
scientia non olet · About Mike's Workshop Manuals