Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2003 >> Outback Base, 4D Sedan >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Manual Trans & Differential) >> Front Differential Assembly >> Disassembly >> Differential Case Assembly

Differential Case Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove right and left snap rings from differential, and then remove two axle drive shafts.
    NOTE: During reassembly, reinstall each axle drive shaft in the same place from which it was removed.
  2. Loosen twelve bolts and remove hypoid driven gear.
    Fig 1: Removing Hypoid Driven Gear
    G02876483Courtesy of SUBARU OF AMERICA, INC.
  3. Drive out straight pin from differential assembly toward hypoid driven gear.
    1. ST 899904100 REMOVER
    Fig 2: Driving Straight Pin From Differential Assembly
    G02876484Courtesy of SUBARU OF AMERICA, INC.
  4. Pull out pinion shaft, and remove differential bevel pinion, gear and washer.
    Fig 3: Removing Differential Bevel Pinion, Gear & Washer
    G02876485Courtesy of SUBARU OF AMERICA, INC.
  5. Remove roller bearing using ST.
    1. ST 899524100 PULLER SET
    Fig 4: Removing Roller Bearing
    G02876486Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals