Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2002 >> Outback Base, 4D Sedan >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Clutch System) >> Clutch Fluid >> Replacement

Clutch Fluid: Replacement

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • The FMVSS No. 116, fresh DOT3 or 4 brake ] fluid must be used.
  • Cover bleeder with waste cloth, when loosening it, to prevent brake fluid from being splashed over surrounding parts.
  • Avoid mixing different brands of brake fluid to prevent degrading the quality of the fluid.
  • Be careful not to allow dirt or dust to get into the reservoir tank.
  • During bleeding operation, keep the clutch reservoir tank filled with brake fluid to eliminate entry of air.
  • Clutch pedal operating must be very slow.
  • For convenience and safety, it is advisable to have two men working.
  • The amount of brake fluid required is approximately 70 (2.4 US fl oz, 2.5 Imp fl oz) for total clutch system.
  1. Remove air cleaner case. Refer to REMOVAL , Air Cleaner Case.
  2. Draw out the brake fluid from reservoir tank with syringe.
  3. Refill reservoir tank with recommended brake fluid.
    1. Recommended brake fluid: FMVSS No. 116, fresh DOT3 or 4 brake ) fluid 
    2. Bleed air from oil line with the help of a co-worker.
    3. Refer to CLUTCH FLUID AIR BLEEDING .
scientia non olet · About Mike's Workshop Manuals