Section 133 (A/T & M/T Control Systems): General Description: Caution

WARNING: This page is about a different car, the 2003 Subaru Outback, 2003 Subaru Legacy, and 2003 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

Wear working clothing, including a cap, protective goggles, and protective shoes during operation.
Remove contamination including dirt and corrosion before removal, installation or disassembly.
Keep the disassembled parts in order and protect them from dust or dirt.
Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly, and replacement.
Use SUBARU genuine grease etc. or the equivalent. Do not mix grease etc. with that of another grade or from other manufacturers.
Be sure to tighten fasteners including bolts and nuts to the specified torque.
Place shop jacks or safety stands at the specified points.
Apply grease onto sliding or revolution surfaces before installation.
Before installing O-rings or snap rings, apply sufficient amount of grease to avoid damage and deformation.
Before securing a part on a vise, place cushioning material such as wood blocks, aluminum plate, or shop cloth between the part and the vise.
Before disconnecting electrical connectors, be sure to disconnect the ground cable from battery.