MT Gear Shift Lever: Installation

WARNING: This page is about a different car, the 2004 Subaru Outback, 2004 Subaru Legacy, and 2004 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

Install the joint to transmission and secure with the spring pin.
Insert the gear shift lever from room side.
NOTE: After inserting the rod and stay, temporarily put them onto transmission mount.

Fig 1: Inserting Gear Shift Lever From Room Side
Courtesy of SUBARU OF AMERICA, INC.
Lift-up the vehicle.
Install the joint to shifter arm.
Insert the spring pin.

Fig 2: Inserting Spring Pin
Courtesy of SUBARU OF AMERICA, INC.
Mount the cushion rubber on the body.
1. Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
Fig 3: Mounting Cushion Rubber On Body
Courtesy of SUBARU OF AMERICA, INC.
Connect the rod to the joint.
1. Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
Fig 4: Connecting Rod To Joint
Courtesy of SUBARU OF AMERICA, INC.
Connect the stay to transmission bracket.
1. Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
Fig 5: Connecting Stay To Transmission Bracket
Courtesy of SUBARU OF AMERICA, INC.
Install the heat shield cover. (If equipped)
Install the rear exhaust pipe and muffler.
Except 2.5 L U5 model

Refer to INSTALLATION , Rear Exhaust Pipe and INSTALLATION , Muffler.

2.5 L U5 model

Refer to INSTALLATION , Rear Exhaust Pipe and INSTALLATION , Muffler.

3.0 L model

Refer to INSTALLATION , Rear Exhaust Pipe and INSTALLATION , Muffler.

TURBO model

Refer to INSTALLATION , Rear Exhaust Pipe and INSTALLATION , Muffler.
Lower the vehicle.
Install the plate ASSY to body.
1. Tightening torque: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
Fig 6: Installing Plate ASSY To Body
Courtesy of SUBARU OF AMERICA, INC.
Install the boot and insulator assembly to vehicle in proper direction.

Fig 7: Installing Boot & Insulator Assembly
Courtesy of SUBARU OF AMERICA, INC.
Install the clamp.
Install the console box. Refer to INSTALLATION , Console Box.