Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2001 >> Forester Base >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System >> Service Procedure >> Lubrication >> Replacement >> Oil Replacement

Oil Replacement

  1. After stabilization and discharge, replace the component, adding the appropriate amount of oil (ZXL200PG) to the new component before installation.
    Fig 1: Refrigerant Oil Capacity Chart
    G02002846
  2. If the compressor is replaced (after stabilization):
    1. Drain and measure the oil from the original compressor.
    2. Drain the oil from the replacement compressor and refill with the same amount that was drained from the original [20 ml (0.7 US fl oz, 0.7 Imp fl oz) minimum]. Always use ZXL200PG for the replacement oil.
scientia non olet · About Mike's Workshop Manuals