Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 1996 >> SVX LSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Trouble Codes >> Code 28 - Knock Sensor No. 2 - L/H

Code 28 - Knock Sensor No. 2 - L/H

NOTE: For ECM harness connector terminal identification, see Figure.
  1. Turn ignition on. Using a DVOM, check voltage between ECM harness connector terminal C6 and ground. Voltage should be 3-4 volts. If voltage is not as specified, go to next step. If voltage is as specified, check ECM harness connector terminals for good contact. Repair as necessary. If harness connector terminals are okay, replace ECM.
  2. Remove collector and disconnect knock sensor harness connector located on side of block. Using an ohmmeter, check resistance between knock sensor terminal and ground. Resistance should be about 560,000 ohms. If resistance is as specified, repair circuit between ECM and knock sensor. If resistance is not as specified, replace knock sensor.
scientia non olet · About Mike's Workshop Manuals