Diagnostic Trouble Code Chart [05/2014 - ]

HINT: 

• If no malfunction is found when inspecting components, inspect the skid control ECU and ground points for poor connections.
• If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details, refer to the "See " reference for the DTC.
• When 2 or more DTCs are detected, perform diagnosis for each DTC, one by one until the problem is identified.
• If DTCs were checked using the warning light or indicator light, refer to the tables in DTC CHECK / CLEAR [05/2014 - ]  to cross-reference them to the 5-digit DTCs shown in the following tables.
• Inspect the fuses and relays before inspecting the trouble areas shown in the following table.

*1, *2:

Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:

• *1:
  1. Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
  2. Clear the DTC.
• *2:
  1. Keep the vehicle stationary for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
  2. Drive the vehicle at a vehicle speed of 50 km/h (31 mph) and keep depressing the brake pedal strongly for approximately 3 seconds.
  3. Repeat the above operation 3 times or more and check that the ABS warning light goes off.
  4. Clear the DTC.