Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Scion >> 2013 >> FR-S Automatic Trans >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System (Diagnostics - Introduction) >> Power Steering System >> DTC Check/Clear [03/2012 - ] >> DTC Check/Clear [03/2012 - ]

DTC Check/Clear [03/2012 - ]

  1. CHECK DTC 
    1. Turn the ignition switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the Techstream on.
    5. Enter the following menus: Chassis/EMPS/Trouble Codes.
    6. Read the DTCs following the display on the Techstream.
    7. Refer to Diagnostic Trouble Code Table for DTC information. Refer to DIAGNOSTIC TROUBLE CODE TABLE [03/2012 - ] .
  2. CLEAR DTC 
    1. Turn the ignition switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the Techstream on.
    5. Enter the following menus: Chassis/EMPS/Trouble Codes.
    6. Clear the DTCs by following the display on the Techstream.
    7. Turn the ignition switch off.
    8. Disconnect the Techstream from the DLC3.
scientia non olet · About Mike's Workshop Manuals