DTC P0500: Vehicle Speed Sensor "A": Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Data List / Vehicle Speed.
5. Drive the vehicle.
6. Read the value displayed on the Techstream.

   OK

   Vehicle speeds displayed on the Techstream and speedometer display are equal.

NG → See step   2 

OK → See step   5 

1. Inspect the circuits that send vehicle speed signals to this system in the meter system. Refer to Speed Signal Circuit .
2. During inspection for the meter section, if there is an instruction that indicates to go back to inspections for each system, proceed to the next step.

NEXT: Go to next step 

1. Disconnect the ECM connector.
2. Disconnect the combination meter connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance (Check for Open)

   Tester Connection	Condition	Specified Condition
   F1-17 (+S) - A21-8 (SPD)	Always	Below 1 Ω

4. Reconnect the ECM connector.
5. Reconnect the combination meter connector.

NG → See step   4 

OK → See step   6 

1. Disconnect the ECM connector.
2. Disconnect the instrument panel junction block assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance (Check for Open)

   Tester Connection	Condition	Specified Condition
   4B-26 - A21-8 (SPD)	Always	Below 1 Ω

4. Reconnect the ECM connector.
5. Reconnect the instrument panel junction block assembly connector.

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY