Slip Indicator Light does not Come ON: Procedure

1. Check if the CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → See step   4 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Start the engine.
3. Select the Active Test on the Techstream. Refer to DATA LIST / ACTIVE TEST .
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Slip Indicator Light	Slip indicator light	Indicator light ON / OFF	Observe combination meter

4. Check that the slip indicator light on the combination meter turns on or off in accordance with the Techstream operation.

   OK

   The slip indicator light turns on or off in accordance with the Techstream.

NG → See step   3 

OK → See step   7 

1. Turn the ignition switch off.
2. Perform Active Test of the combination meter (meter CPU) using the Techstream. Refer to DATA LIST / ACTIVE TEST .
3. Check the combination meter.

   OK

   The slip indicator light turns ON or OFF in accordance with the Techstream.

NG → See step   6 

OK → See step   5