Skid Control Buzzer Circuit: Procedure

1. Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   DTC not output	A
   DTC output	B

B → See step   6 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
5. According to the display on the Techstream, perform the Active Test.
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Buzzer	Skid control buzzer	Buzzer ON / OFF	Buzzer can be heard

6. Check that the buzzer sounds or stops in accordance with the Techstream.
   RESULT
   
   

   Result	Proceed to
   Buzzer does not sound or stop constantly	A
   Buzzer sounds and stops	B

   HINT: 

   If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part. Refer to PROBLEM SYMPTOMS TABLE .

B → See step   5 

A: Go to next step 

1. Turn the ignition switch off.
2. Replace the combination meter. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
5. According to the display on the Techstream, perform the Active Test.
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Buzzer	Skid control buzzer	Buzzer ON / OFF	Buzzer can be heard

6. Check that the buzzer sounds or stops in accordance with the Techstream.
   RESULT
   
   

   Result	Proceed to
   Buzzer does not sound or stop constantly	A
   Buzzer sounds and stops	B

   HINT: 

   If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part. Refer to PROBLEM SYMPTOMS TABLE .

B → END 

A → See step   5