DTC C1434: Steering Angle Sensor Output Malfunction: Procedure

1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Turn the ignition switch off.
3. Turn the ignition switch to ON again and check that no CAN communication system DTC is output. Refer to DTC CHECK / CLEAR .
4. Start the engine.
5. Drive the vehicle at a speed of 35 km/h (22 mph), turn the steering wheel to the right and left and check that no speed sensor or yaw rate and acceleration sensor DTCs are output. Refer to DTC CHECK / CLEAR .
   RESULT
   
   

   Result	Proceed to
   No CAN communication system, speed sensor, or yaw rate and acceleration sensor DTCs are output	A
   CAN communication system DTC is output	B
   Speed sensor or yaw rate and acceleration sensor DTC is output	C

   HINT: 

   • If there is a malfunction in any of the speed sensors or the yaw rate and acceleration sensor, an abnormal value may be output although the steering angle sensor is normal.
   • If speed sensor and yaw rate and acceleration sensor DTCs are output simultaneously, repair these two sensors first, and then inspect the steering angle sensor.

B → See step   5 

C → See step   6 

A: Go to next step 

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (IG/BAT CIRCUIT) 

OK: Go to next step 

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (ESS CIRCUIT) 

OK → See step   4