DTC C1433: Steering Angle Sensor Internal Circuit: Procedure
- REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (STEERING ANGLE SENSOR)
- Replace the spiral with sensor cable sub-assembly. Refer to REMOVAL
.NOTE:
- Do not remove the steering sensor from the spiral with sensor cable sub-assembly.
- When replacing the spiral with sensor cable sub-assembly, confirm that the replacement part is of the correct specification.
HINT:
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next suspected area. Refer to PROBLEM SYMPTOMS TABLE .
NEXT → END
- Replace the spiral with sensor cable sub-assembly. Refer to REMOVAL
.