Inspection Procedure

1. Using an intelligent tester or Techstream, perform the Active Test.
   1. Intelligent tester

      COMBINATION METER 

      DATA LIST
      
      

      Tester Display	Test Part	Control Range	Diagnostic Note
      CRUISE INDIC	Turns CRUISE main indicator light	ON/OFF	-

   2. Techstream

      Combination Meter 

      DATA LIST
      
      

      Tester Display	Test Part	Control Range	Diagnostic Note
      Indicat Lamp Cruise	Turns CRUISE main indicator light	ON/OFF	-

      OK: Indicator light comes on/goes off. 

NG : REPLACE COMBINATION METER  (See REMOVAL )

OK: Go to next step. 

1. Using the intelligent tester or Techstream, read the Data List.
   1. Intelligent tester

      ECM (Cruise control) 

      DATA LIST
      
      

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      CCS INDICATOR M	Cruise indicator signal (Main CPU)/ON or OFF	ON "CRUISE" on OFF "CRUISE" off	-

   2. Techstream

      Cruise control 

      DATA LIST
      
      

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      CCS Indicator M-CPU	Cruise indicator signal (Main CPU)/ON or OFF	ON "CRUISE" on OFF "CRUISE" off	-

      OK: When cruise control main switch operation is performed, the result will be same as above. 

NG : REPLACE ECM  (See REMOVAL )

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE  .