Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Scion >> 2004 >> xA Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2425 (Engine Control System - DTCS P1148 To P2A03) >> DTC P1572 ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    STOP LAMP SWITCH

    Condition Continuity
    Brake pedal: Fully released Should not exist
    Brake pedal: Slightly depressed Should exist
    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04900678Courtesy of NISSAN MOTOR CO., U.S.A.

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.

scientia non olet · About Mike's Workshop Manuals