Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Relearn >> Driver Information Center (DIC) Method

Driver Information Center (DIC) Method

NOTE: Before proceeding with the steps below, ensure that no other sensor learn procedure is being performed simultaneously, or that no tire pressures are being adjusted on another TPM equipped vehicle within close proximity.
  1. Turn ignition switch to RUN position. Apply parking brake.
  2. Press the "INFO" button on the DIC, until the "RELEARN TIRE POSITIONS" message display on the DIC. Then press the "SET/RESET" button on the DIC, until a double horn chirp will sound. The DIC will display "TIRE LEARNING ACTIVE" message indicating the learn mode has been enabled.
  3. Starting with Left Front tire, use either of the following sensor activation methods:
    • Increase/Decrease Method:  Increase or decrease the pressure for 8-10 seconds, then wait for a horn chirp sound. The horn chirp may occur before the 8-10 second pressure increase/decrease time period has been reached, or up to 30 seconds after the 8-10 second pressure increase/decrease time period has been reached.
    • TPM Sensor Activation Tool Method:  Hold the tool against the tire wall aiming upward with the antenna. Press the activate button and wait for a horn chirp. After the horn has chirped, the turn signal will illuminate indicating the next location to be learned.
  4. After horn chirp has sounded and the right turn signal has illuminated, repeat procedure for the next 3 sensors in the following order: Right Front, Right Rear, Left Rear.
  5. After left rear sensor has been learned, a double horn chirp will sound, indicating all 4 sensor IDs have been learned. Turn ignition switch to OFF position. Adjust all tire pressures to specification.
scientia non olet · About Mike's Workshop Manuals