Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 3.5L - Introduction) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Knock Sensor
    GM1800587Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Position the knock sensor to the engine block and install the knock sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    2. Fig 2: Knock Sensor
    GM1887295Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (3) to the knock sensor (2).
  3. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals