Air Cleaner Assembly Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Air Cleaner Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement (HP7) or Underhood Electrical Center or Junction Block Replacement (HP5) . Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
1	Air Cleaner Assembly Bolt CAUTION: Refer to Fastener Caution . Tighten: 8 N.m (71 lb in)
2	Air Cleaner Assembly Bolt (Qty: 2) Tighten: 6 N.m (53 lb in)
3	Air Cleaner Assembly Procedure Disconnect any electrical connectors as needed. Transfer any parts as needed.