Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 596 (HVAC System - Automatic) >> Repair Instructions >> Inside Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the inside air temperature sensor electrical connector.
    2. IMPORTANT: Ensure that the inside temperature sensor is fully seated into the driver information center bezel.
    Fig 1: View Of Inside Air Temperature Sensor Electrical Connector
    GM922611Courtesy of GENERAL MOTORS CORP.
  2. Install the inside air temperature sensor.
  3. Connect the driver information center to the I/P.
    4. NOTE: Refer to Fastener Notice .
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  4. Install the driver information center retaining screw.

    Tighten:  Tighten the screw to 1.9 N.m (17 lb in).

  5. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement .
scientia non olet · About Mike's Workshop Manuals