Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 558 (Power Door Lock System And Release Systems) >> Repair Instructions >> Door Lock Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear cover from the replacement lock.
  2. Install the cable ends onto the replacement lock by engaging the cable end into the lock-actuating lever and rotating the cable a quarter turn.
    3. Fig 1: View Of Latch & Lock Cover Fasteners
    GM1291920Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: The rear release is attached to the lock upper lever. The floor mounted release cable is attached to the lower lever.
  3. Seat the cable's sheath into the molded lock cover recess and install the lock cover fasteners.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    4. Fig 2: View Of Electrical Connector Lock
    GM929153Courtesy of GENERAL MOTORS CORP.
  4. Install the electrical connector (2) and slide the connector lock (1) to the seated position on the door lock mechanism.
    5. Fig 3: View Of Latch, Lock & Fastener
    GM1070834Courtesy of GENERAL MOTORS CORP.
  5. Place the lock (1) in the B-Pillar body access hole, aligning the fastener (3) holes to the body.
    6. Fig 4: View Of B-Pillar Mounted Door Latch, Cover Plate & Fasteners
    GM1070880Courtesy of GENERAL MOTORS CORP.
  6. Install the fasteners (1) through the cover plate (2) and to the B-Pillar mounted door lock (3).

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    7. Fig 5: View Of Door Latch Access Hole Mastic Cover
    GM1071088Courtesy of GENERAL MOTORS CORP.
  7. Install a new mastic cover (1) over the door lock access hole.
  8. Reconnect the battery.
  9. Verify the manual and electrical functions of the lock.
    • Door lock release handle - interior floor mounted
    • Door lock release handle - rear compartment mounted
    • Door lock release handle - interior door panel push button
    • Door lock release handle - exterior door touch pad
  10. Install the B-pillar trim panel. Refer to Body Lock Pillar Trim Panel Replacement .
  11. Install the door sill cover. Refer to Carpet Retainer Replacement .
  12. Move the seat to the original position.
scientia non olet · About Mike's Workshop Manuals