Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2009 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1149 (Power Door Lock System And Release Systems) >> Diagnostic Information and Procedures >> DTC B2976 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect harness connector at the driver door latch assembly.
  2. Test for less than 10 ohms between the ground circuit terminal 8 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the door ajar indicator is not illuminated.
    • If the indicator is illuminated, test the signal circuit terminal 6 for a short to ground. If the circuit tests normal, replace the BCM.
  4. Install a 3A fused jumper wire between the signal circuit terminal 6 and the ground circuit terminal 8. Verify that the door ajar indicator is illuminated.
    • If the indicator is not illuminated, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuit tests normal, test or replace the driver door latch assembly.
scientia non olet · About Mike's Workshop Manuals