Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2009 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Engine Controls And Fuel - 2.4L - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Sky and 2010 Pontiac Solstice. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Rotate the pigtail 90 degrees from vertical before securing the fastener.
    Fig 1: Identifying Knock Sensor
    GM1578476Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the KS.
  2. Install the KS bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Engine Harness Electrical Connectors
    GM1590505Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the KS electrical connector (3).
  4. Install the KS electrical connector clip to the oil level indicator tube bracket.
scientia non olet · About Mike's Workshop Manuals