Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2009 >> Sky Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 2.0L - Introduction) >> Repair Instructions >> Intake Air Pressure and Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Intake Air Pressure And Temperature Sensor Electrical Connector
    GM1826861Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (2) from the intake air pressure and temperature sensor.
    2. Fig 2: View Of Intake Air Pressure And Temperature Sensor
    GM1829737Courtesy of GENERAL MOTORS CORP.
  2. Remove the intake air pressure and temperature sensor bolts.
  3. Remove the intake air pressure and temperature sensor.
scientia non olet · About Mike's Workshop Manuals