Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2009 >> Sky Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 2.0L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    NOTE: Inspect the CMP sensor for damage, replace as necessary.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor bolt and tighten to 10 N.m (89 lb in).
    4. Fig 2: Identifying High Pressure Fuel Pump Connector & Clip
    GM1826282Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (2) to the intake CMP sensor.
  5. Install the fuel feed intermediate pipe. Refer to Fuel Feed Intermediate Pipe Replacement .
scientia non olet · About Mike's Workshop Manuals