Installation Procedure
- Install the cable to inner door actuation.
Push the cable back into lock and clip into bracket.
- Install the front door lock.
Install the connector linkage of the lock cylinder and install the lock.
Tighten: Tighten the 3 bolts to 8 N.m (70 lb in).
- Connect the lock catch wiring harness plug.
Connect and latch the wiring harness plug.
- Fasten the fastening pins between the door handle and lock.
Install the fastening pins and clip the plastic retainer.
- Install the water vapor barrier.
Install the 2 front door retainer base inner paneling.
- Install the front side door trim panel. Refer to Front Side Door Trim Panel Replacement (Coupe) or Front Side Door Trim Panel Replacement (Sedan) .
CAUTION:
Refer to Fastener Caution
.