Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2008 >> Vue Red Line, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Installation Procedure

Installation Procedure

    Fig 1: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Position the knock sensor and tighten the knock sensor bolt.

    Tighten:  Tighten the bolt to 23 N.m (17 lb ft).

    2. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1836545Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (2) to the bank 1 knock sensor.
  3. Install the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (LAT, LE5) .
  4. Install the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LY7) .
scientia non olet · About Mike's Workshop Manuals