Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2008 >> Vue Red Line, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Crankshaft Position (CKP) Sensor
    GM1311144Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft position sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the crankshaft position sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1836545Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector to the CKP sensor.
  4. If equipped with all AWD, install the transfer case. Refer to Transfer Case Assembly Replacement (LY7) .
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals