Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2008 >> Vue Red Line, AWD >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Turning Ignition Lock Cylinder To RUN Position
    GM874786Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If you are installing a new ignition lock cylinder, refer to Key and Lock Cylinder Coding .
  1. Position the ignition lock cylinder in the run position and insert it into the ignition/start switch housing.
  2. Rotate the ignition lock cylinder in the housing and verify proper rotation.
  3. Install the wipers/washer switch. Refer to Windshield Wiper and Washer Switch Replacement
scientia non olet · About Mike's Workshop Manuals