Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2008 >> Vue Red Line, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Diagnostic Information and Procedures >> Cruise Control Switch Indicator Inoperative >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the steering wheel controls switch - left.
  2. Connect a fused jumper wire between the voltage reference circuit terminal 1 and the cruise control indicator signal circuit terminal 9.
  3. Engine ON, observe the Cruise On/Off Switch parameter.
    • If the Cruise On/Off Switch parameter displays ON, replace the steering wheel controls switch - left.
    • If the Cruise On/Off Switch parameter displays OFF, test the voltage signal circuit and the low reference circuit for an open/high resistance.
  4. If all circuits test normal, replace the BCM.
scientia non olet · About Mike's Workshop Manuals