Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2008 >> Vue Green Line >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.4L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement - Intake >> Installation Procedure

Installation Procedure

    Fig 1: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Inspect the intake CMP sensor for damage, replace as necessary.
  1. Lubricate the intake CMP sensor O-ring seal with clean engine oil.
  2. Install the intake CMP sensor.
    3. NOTE: Refer to Fastener Notice .
  3. Install the intake CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Locating Intake Camshaft Position Sensor And Intake Camshaft Position Sensor Connectors
    GM1815154Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (1) to the intake CMP sensor.
scientia non olet · About Mike's Workshop Manuals