Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2008 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Suspension Control System - Automatic Level Control (ASCM)) >> Diagnostic Information & Procedures >> DTC C0713 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that there are no air leaks in the system.
    • If a leak is found, repair or replace the leaking component as necessary.
  2. Ignition ON, verify that the air suspension compressor is not mechanically binding.
    • If a mechanical condition is found, replace the air suspension compressor.
  3. Observe the scan tool Compressor Temperature parameter, the parameter should display OK.
    • If not the specified value, test or replace the air suspension compressor.
  4. Clear the DTC with the scan tool and run the air suspension compressor with the scan tool output control. The DTC should not reset.
    • If DTC C0713 resets, replace the air suspension control module.
scientia non olet · About Mike's Workshop Manuals