Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2008 >> Sky Red Line, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.0L - Introduction (2 Of 2) >> Repair Instructions >> Intake Air Pressure & Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Intake Air Pressure & Temperature Sensor & Bolts
    GM1829737Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the intake air pressure and temperature sensor O-ring with clean engine oil.
  2. Install the intake air pressure and temperature sensor.
    3. NOTE: Refer to Fastener Notice .
  3. Install the intake air pressure and temperature sensor bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    4. Fig 2: Intake Air Pressure & Temperature Sensor Electrical Connector
    GM1826861Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (2) to the intake air pressure and temperature sensor.
scientia non olet · About Mike's Workshop Manuals