Circuit/System Testing
- Ignition OFF. Disconnect the harness connectors at the EBCM.
- Verify there is less than 3 ohms between the ground circuit terminals 13 and 26 to ground.
- If greater than the specified value, test the ground circuits for an open/high resistance.
- Ignition ON, verify a test lamp illuminates between the ignition voltage circuit terminal 20 and ground.
- If the test lamp did not illuminate, test the ignition voltage circuit for a short to ground or an open/high resistance.
- Ignition ON, verify a test lamp illuminates between the battery positive voltage circuits terminals 1-14-44 and ground.
- If the test lamp did not illuminate, test the affected battery positive voltage circuit for a short to ground or an open/high resistance.
- If all the circuits test normal, replace the EBCM.