Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saturn >> 2008 >> Astra XE, Standard >> Repair and Diagnosis >> Steering >> Power Steering System >> Diagnostic Information and Procedures >> DTC C1523 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the B+ harness connector at the power steering module.
  2. Test for less than 5.0 Ohm between the ground circuit terminal listed below and ground.
    • Connector X2, terminal 2
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Verify that the test lamp illuminates between the B+ circuit terminals listed below and ground.
    • Terminal Connector X2, terminal 40
    • Terminal Connector X3, terminal 1
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. If all circuits test normal, replace the power steering module.
scientia non olet · About Mike's Workshop Manuals